# Estlcam beginner **URL:** \ **Category:** General Discussion\ **Created:** [November 2, 2024, 7:07pm UTC](https://forum.arcdroidcnc.com/t/estlcam-beginner/4623 "2024-11-02T19:07:28Z")\ **Posts on this page:** 1\ **Showing post:** 5
**Author:** ![Middyeasy](https://avatars.discourse-cdn.com/v4/letter/m/9d8465/32.png) [@Middyeasy](https://forum.arcdroidcnc.com/u/Middyeasy)\ **Post date:** [November 3, 2024, 9:25pm UTC](https://forum.arcdroidcnc.com/t/estlcam-beginner/4623/5 "2024-11-03T21:25:25Z")
> [@EstlCam Setup](https://forum.arcdroidcnc.com/t/estlcam-setup/4340): > > Hello, I thought i would post a quick how to setup EstlCam and bust out a quick gcode with it. Simple Trace can do all of this by simply loading the DXF but if its a busy file ( ie very organic in nature) then it might be worth taking the time to set it up before hand OR if has too many segments and and you get the the file too big error. Then you would set the zero point once and then run once: each path file after the other. Ie All the interior paths then the finally the exterior to cut the p… --- _[View the full topic](https://forum.arcdroidcnc.com/t/estlcam-beginner/4623)._