# Hypertherm 65 sync hand torch connection

**URL:** <https://forum.arcdroidcnc.com/t/hypertherm-65-sync-hand-torch-connection/3454>\
**Category:** General Discussion\
**Created:** [November 13, 2023, 11:44pm UTC](https://forum.arcdroidcnc.com/t/hypertherm-65-sync-hand-torch-connection/3454 "2023-11-13T23:44:40Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![BobD](https://avatars.discourse-cdn.com/v4/letter/b/bcef8e/32.png) [@BobD](https://forum.arcdroidcnc.com/u/BobD)\
**Post date:** [November 14, 2023, 5:24pm UTC](https://forum.arcdroidcnc.com/t/hypertherm-65-sync-hand-torch-connection/3454/4 "2023-11-14T17:24:47Z")

</div>

I have a Hypertherm45. I bet our wiring is similar. Look at this thread for my posts on hookup. You’ll have to open up your cutter to see if it is the same idea. [Powermax 45 hook up](https://forum.arcdroidcnc.com/t/powermax-45-hook-up/476)

---

_[View the full topic](https://forum.arcdroidcnc.com/t/hypertherm-65-sync-hand-torch-connection/3454)._