# Hypertherm + Plasma Table + EasyScriber = Easy numbering of this tool index
**URL:** https://forum.arcdroidcnc.com/t/hypertherm-plasma-table-easyscriber-easy-numbering-of-this-tool-index/3312
**Category:** General Discussion
**Created:** [September 23, 2023, 12:48pm UTC](https://forum.arcdroidcnc.com/t/hypertherm-plasma-table-easyscriber-easy-numbering-of-this-tool-index/3312 "2023-09-23T12:48:38Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@Geantvert](https://forum.arcdroidcnc.com/u/Geantvert)
#### Post date: [September 23, 2023, 12:48pm UTC](https://forum.arcdroidcnc.com/t/hypertherm-plasma-table-easyscriber-easy-numbering-of-this-tool-index/3312/1 "2023-09-23T12:48:38Z")
[ ](https://www.youtube.com/watch?v=WtyFHuJQ6Xw)
do you think it is possible to use on ArcDroid?
---
### Author:  [@Beandip](https://forum.arcdroidcnc.com/u/Beandip)
#### Post date: [September 25, 2023, 1:28pm UTC](https://forum.arcdroidcnc.com/t/hypertherm-plasma-table-easyscriber-easy-numbering-of-this-tool-index/3312/2 "2023-09-25T13:28:21Z")
I don’t see why not. I toss a sharpie in the stylus holder if I have to verify something during prototyping.
---
### Author:  [@Geantvert](https://forum.arcdroidcnc.com/u/Geantvert)
#### Post date: [September 25, 2023, 3:37pm UTC](https://forum.arcdroidcnc.com/t/hypertherm-plasma-table-easyscriber-easy-numbering-of-this-tool-index/3312/3 "2023-09-25T15:37:12Z")
I wonder about the pressure exerted on the tip. will the arcdroid be able to perform this task with the arm deployed?
---
### Author:  [@Andrew](https://forum.arcdroidcnc.com/u/Andrew)
#### Post date: [September 27, 2023, 2:57pm UTC](https://forum.arcdroidcnc.com/t/hypertherm-plasma-table-easyscriber-easy-numbering-of-this-tool-index/3312/4 "2023-09-27T14:57:37Z")
@Geantvert
We’ve tried it. It works
You do need to experiment with the pierce an cut heights a bit an it is a little inconsitant close vs far away to the machine. But it will work
cheers
AM