# Limit switch covers

**URL:** <https://forum.arcdroidcnc.com/t/limit-switch-covers/6150>\
**Category:** General Discussion\
**Created:** [October 11, 2026, 1:58pm UTC](https://forum.arcdroidcnc.com/t/limit-switch-covers/6150 "2026-10-11T13:58:33Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![midy](https://avatars.discourse-cdn.com/v4/letter/m/48db29/32.png) [@midy](https://forum.arcdroidcnc.com/u/midy)\
**Post date:** [October 11, 2026, 1:58pm UTC](https://forum.arcdroidcnc.com/t/limit-switch-covers/6150/1 "2026-10-11T13:58:33Z")

</div>

Is there any reason to not cover the top of the limit switches ? They look a little unfinished to me but maybe there is good reason for it? I’ve printed some covers which look far nicer than bare PCB. Maybe arcdroid will answer this?

---

<div class="post-metadata">

**Author:** ![Jdd](https://avatars.discourse-cdn.com/v4/letter/j/db5fbb/32.png) [@Jdd](https://forum.arcdroidcnc.com/u/Jdd)\
**Post date:** [October 11, 2026, 8:31pm UTC](https://forum.arcdroidcnc.com/t/limit-switch-covers/6150/2 "2026-10-11T20:31:50Z")

</div>

Do you have pictures installed, hard to say without seeing what you have done

---

<div class="post-metadata">

**Author:** ![GregKet1](https://avatars.discourse-cdn.com/v4/letter/g/e68b1a/32.png) [@GregKet1](https://forum.arcdroidcnc.com/u/GregKet1)\
**Post date:** [October 18, 2026, 3:44pm UTC](https://forum.arcdroidcnc.com/t/limit-switch-covers/6150/3 "2026-10-18T15:44:11Z")

</div>

If you are using the “ArcDroid Sensor Covers” from Makerworld, they work great. I’ve been using them on my ‘droid for several months now.