# My arcdroid in a dirty shop

**URL:** <https://forum.arcdroidcnc.com/t/my-arcdroid-in-a-dirty-shop/3161>\
**Category:** Gallery\
**Created:** [August 7, 2023, 8:07pm UTC](https://forum.arcdroidcnc.com/t/my-arcdroid-in-a-dirty-shop/3161 "2023-08-07T20:07:54Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Jdd](https://avatars.discourse-cdn.com/v4/letter/j/db5fbb/32.png) [@Jdd](https://forum.arcdroidcnc.com/u/Jdd)\
**Post date:** [August 7, 2023, 8:07pm UTC](https://forum.arcdroidcnc.com/t/my-arcdroid-in-a-dirty-shop/3161/1 "2023-08-07T20:07:54Z")

</div>

This shows how I set up my Droid , if you look close you can see I used a trolling motor quick connect that way I don’t have to disconnect the wiring on the back. The tool holder is just an 1 1/2 inch square tubing with a bolt running through it lightly welded

 ![thumbnail (2)](https://us1.discourse-cdn.com/flex016/uploads/arcdroidcnc/original/1X/77f8174ed76a57052da79627d7eafe7508443686.jpeg)  
 ![thumbnail (3)](https://us1.discourse-cdn.com/flex016/uploads/arcdroidcnc/original/1X/7c08c1226364842f98454052fac6f75762c93da7.jpeg)  
 ![thumbnail (4)](https://us1.discourse-cdn.com/flex016/uploads/arcdroidcnc/original/1X/27a760f37432e7e1b113081882b8c6ea57fbc7c1.jpeg)  
 ![thumbnail (5)](https://us1.discourse-cdn.com/flex016/uploads/arcdroidcnc/original/1X/4af75fb3f0675581545f36f401e877f9825c50c1.jpeg)  
 ![thumbnail](https://us1.discourse-cdn.com/flex016/uploads/arcdroidcnc/original/1X/c9dedad96b676a09cb33c862677430c4362e8a15.jpeg)  
If you have any questions just ask.