# Newbie question **URL:** \ **Category:** General Discussion\ **Created:** [December 29, 2024, 1:28pm UTC](https://forum.arcdroidcnc.com/t/newbie-question/4824 "2024-12-29T13:28:58Z")\ **Posts on this page:** 4\ **Page:** 1
**Author:** ![Wozza](https://sea2.discourse-cdn.com/flex016/user_avatar/forum.arcdroidcnc.com/wozza/32/2004_2.png) [@Wozza](https://forum.arcdroidcnc.com/u/Wozza)\ **Post date:** [December 29, 2024, 1:28pm UTC](https://forum.arcdroidcnc.com/t/newbie-question/4824/1 "2024-12-29T13:28:58Z")
For reasons I wont bore you with, my Arcdroid will be about 20mm higher than the cutting surface, I haven’t used the Arcdroid yet but wondered if this is possible and/or what issues I might have. TIA ---
**Author:** ![Matt\_UK](https://avatars.discourse-cdn.com/v4/letter/m/65b543/32.png) [@Matt\_UK](https://forum.arcdroidcnc.com/u/Matt_UK)\ **Post date:** [December 29, 2024, 1:47pm UTC](https://forum.arcdroidcnc.com/t/newbie-question/4824/2 "2024-12-29T13:47:54Z")
None really- there are lots of adjustments’ for torch height ---
**Author:** ![Wozza](https://sea2.discourse-cdn.com/flex016/user_avatar/forum.arcdroidcnc.com/wozza/32/2004_2.png) [@Wozza](https://forum.arcdroidcnc.com/u/Wozza)\ **Post date:** [December 29, 2024, 2:21pm UTC](https://forum.arcdroidcnc.com/t/newbie-question/4824/3 "2024-12-29T14:21:21Z")
Thanks Matt Just been watching some of your videos, you have the arcdroid proper dialed in 🤘 ---
**Author:** ![Oldbike99](https://avatars.discourse-cdn.com/v4/letter/o/ed655f/32.png) [@Oldbike99](https://forum.arcdroidcnc.com/u/Oldbike99)\ **Post date:** [December 29, 2024, 5:31pm UTC](https://forum.arcdroidcnc.com/t/newbie-question/4824/4 "2024-12-29T17:31:27Z")
If you feel that it is necessary, as I have, the torch carrier is mounted in a dovetail which will allow you to better center the z-height.