# Offset Weirdness **URL:** \ **Category:** General Discussion\ **Created:** [December 16, 2024, 12:00am UTC](https://forum.arcdroidcnc.com/t/offset-weirdness/4784 "2024-12-16T00:00:12Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![Eric\_S](https://avatars.discourse-cdn.com/v4/letter/e/aca169/32.png) [@Eric\_S](https://forum.arcdroidcnc.com/u/Eric_S)\ **Post date:** [December 16, 2024, 1:09am UTC](https://forum.arcdroidcnc.com/t/offset-weirdness/4784/2 "2024-12-16T01:09:33Z")
I found an answer: > [@Edit cut side on imported dxf file](https://forum.arcdroidcnc.com/t/edit-cut-side-on-imported-dxf-file/3446/2): > > @DokHoliday When you Import a .DXF there is a setting for a Global L/C R/C C/C that is applied to all of the lines (don’t forget to add some Lead length) After that you can go into Trace and edit individual curves by zooming in and selectin the cure you want to change (It’ll turn Red) and then select the “Edit” button. You can then flip the L/R cut and change lead for that curve only Cheers AM …but I’m still having issues. The path matches the DXF when I’m looking at it in Trace. The path goes wrong when I save an go to run, it’s acting like some of the paths are open. I am sure they are all closed because 1) I generated this in SolidWorks which has shading for closed loops, and 2) Everything looks correct in Trace. This will be my first time cutting with my Arcdroid! --- _[View the full topic](https://forum.arcdroidcnc.com/t/offset-weirdness/4784)._