# Post processor

**URL:** <https://forum.arcdroidcnc.com/t/post-processor/3632>\
**Category:** General Discussion\
**Created:** [December 16, 2023, 5:38pm UTC](https://forum.arcdroidcnc.com/t/post-processor/3632 "2023-12-16T17:38:05Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Welder10](https://avatars.discourse-cdn.com/v4/letter/w/839c29/32.png) [@Welder10](https://forum.arcdroidcnc.com/u/Welder10)\
**Post date:** [December 16, 2023, 5:38pm UTC](https://forum.arcdroidcnc.com/t/post-processor/3632/1 "2023-12-16T17:38:05Z")

</div>

Would anyone have step by step instructions for setting up the post processer in fusion 360 can’t seem to figure it out

---

<div class="post-metadata">

**Author:** ![Andrew](https://sea2.discourse-cdn.com/flex016/user_avatar/forum.arcdroidcnc.com/andrew/32/52_2.png) [@Andrew](https://forum.arcdroidcnc.com/u/Andrew)\
**Post date:** [December 18, 2023, 6:23pm UTC](https://forum.arcdroidcnc.com/t/post-processor/3632/2 "2023-12-18T18:23:40Z")

</div>

Here’s a thread that’ll help

> [@Unable to find upload post processor to fusion 360 please help](https://forum.arcdroidcnc.com/t/unable-to-find-upload-post-processor-to-fusion-360-please-help/2805):
>
> hi all me again. ive just watched the video about putting a dxf file to usb for arc droid. at the end of the video its mentioned that acrdroid post processor software is required. ive dowloaded the softward but unable to go any further only option windows gives me is to open the file as a word document. what am i doing so wrong. sorry in advance im new to cad thanks . jake.

---

<div class="post-metadata">

**Author:** ![fzr400](https://sea2.discourse-cdn.com/flex016/user_avatar/forum.arcdroidcnc.com/fzr400/32/1699_2.png) [@fzr400](https://forum.arcdroidcnc.com/u/fzr400)\
**Post date:** [September 3, 2024, 11:46am UTC](https://forum.arcdroidcnc.com/t/post-processor/3632/3 "2024-09-03T11:46:54Z")

</div>

I used these instructions and it worked. It’s a bit convoluted to get 360 set up for a plasma torch, and to pick the paths for the profile tool paths, but it does work. I only got it working late yesterday, so I am hoping I find an easier method after playing with it more:  
[https://help.autodesk.com/view/fusion360/ENU/?caas=caas/sfdcarticles/sfdcarticles/How-to-install-a-cloud-post-in-Fusion-360.html](https://help.autodesk.com/view/fusion360/ENU/?caas=caas/sfdcarticles/sfdcarticles/How-to-install-a-cloud-post-in-Fusion-360.html)