# Problems with the last simple trace download **URL:** \ **Category:** General Discussion\ **Created:** [December 11, 2025, 2:41pm UTC](https://forum.arcdroidcnc.com/t/problems-with-the-last-simple-trace-download/5677 "2025-12-11T14:41:14Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![perryharris](https://avatars.discourse-cdn.com/v4/letter/p/838e76/32.png) [@perryharris](https://forum.arcdroidcnc.com/u/perryharris)\ **Post date:** [December 11, 2025, 2:41pm UTC](https://forum.arcdroidcnc.com/t/problems-with-the-last-simple-trace-download/5677/1 "2025-12-11T14:41:14Z")
On DEC. 8/2025 I downloaded the simple trace update . Well when I loaded it into arcdroid things went bad. First recalibrating was a extreme pain failed every time. I checked everything over and over again. Then just for giggle’s I plugged the X2 into the droid and did the recalibrating again. This time it worked. Butt, when I went to use the auto level feature it would pick up the 3 points fine. But would not allow me to turn it on it just stayed off . I got up set and reloaded the previous simple trace download and all works fine. And recalibrating was a breeze no problems at all. And auto level works fine to. What’s up?? I will keep eye out for other post on this. ps thanks for reading . ---
**Author:** ![bobplewajr](https://sea2.discourse-cdn.com/flex016/user_avatar/forum.arcdroidcnc.com/bobplewajr/32/156_2.png) [@bobplewajr](https://forum.arcdroidcnc.com/u/bobplewajr)\ **Post date:** [December 30, 2025, 3:42am UTC](https://forum.arcdroidcnc.com/t/problems-with-the-last-simple-trace-download/5677/2 "2025-12-30T03:42:44Z")
@perryharris I had the same troubles with toggling Auto Level on and off. It started with the November update. I emailed Andrew last week. He just confirmed today that the fix is in the latest December 11 SimpleTrace and firmware updates. I’ll update tomorrow to confirm the correction.