# Torch cut always aslant

**URL:** https://forum.arcdroidcnc.com/t/torch-cut-always-aslant/2398
**Category:** General Discussion
**Created:** [April 19, 2023, 4:41am UTC](https://forum.arcdroidcnc.com/t/torch-cut-always-aslant/2398 "2023-04-19T04:41:25Z")
**Posts on this page:** 3
**Page:** 1

<div class="post-metadata">

### Author: ![Cedubagger](https://avatars.discourse-cdn.com/v4/letter/c/e19adc/32.png) [@Cedubagger](https://forum.arcdroidcnc.com/u/Cedubagger)
#### Post date: [April 19, 2023, 4:41am UTC](https://forum.arcdroidcnc.com/t/torch-cut-always-aslant/2398/1 "2023-04-19T04:41:25Z")

</div>

Hi im Cedric from Switzerland  
I have a litle question  
I use a p80 torch and mi cuts are always aslant.  
Can anybody help me?

---

<div class="post-metadata">

### Author: ![Jdd](https://avatars.discourse-cdn.com/v4/letter/j/db5fbb/32.png) [@Jdd](https://forum.arcdroidcnc.com/u/Jdd)
#### Post date: [September 19, 2023, 6:45pm UTC](https://forum.arcdroidcnc.com/t/torch-cut-always-aslant/2398/2 "2023-09-19T18:45:06Z")

</div>

You’re torch maybe mounted a hair off center, I wish they would make better hold clamps, mine took forever to get it dialed in.

---

<div class="post-metadata">

### Author: ![Jdd](https://avatars.discourse-cdn.com/v4/letter/j/db5fbb/32.png) [@Jdd](https://forum.arcdroidcnc.com/u/Jdd)
#### Post date: [September 19, 2023, 6:48pm UTC](https://forum.arcdroidcnc.com/t/torch-cut-always-aslant/2398/3 "2023-09-19T18:48:01Z")

</div>

Sorry I didn’t look how old this post was did you figure out your problem, how did you fix it?