# X2 track installation question

**URL:** <https://forum.arcdroidcnc.com/t/x2-track-installation-question/5713>\
**Category:** General Discussion\
**Created:** [December 31, 2025, 5:03pm UTC](https://forum.arcdroidcnc.com/t/x2-track-installation-question/5713 "2025-12-31T17:03:49Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Stu](https://avatars.discourse-cdn.com/v4/letter/s/3ec8ea/32.png) [@Stu](https://forum.arcdroidcnc.com/u/Stu)\
**Post date:** [December 31, 2025, 5:03pm UTC](https://forum.arcdroidcnc.com/t/x2-track-installation-question/5713/1 "2025-12-31T17:03:49Z")

</div>

New to the forum, I am in the process of building my water table. its built perfectly level and square. I purchased the X2 and was going to install it today. When I place it on the table it is not level by almost 1/2 an inch. Is this normal. I think when I bolt it down it will straighten/flatten out but wanted to see if this is normal before I install. Or did I get a bad one? Thanks in Advance from Vancouver Island, Canada

---

<div class="post-metadata">

**Author:** ![Dale1953](https://avatars.discourse-cdn.com/v4/letter/d/ea5d25/32.png) [@Dale1953](https://forum.arcdroidcnc.com/u/Dale1953)\
**Post date:** [January 3, 2026, 12:30pm UTC](https://forum.arcdroidcnc.com/t/x2-track-installation-question/5713/2 "2026-01-03T12:30:39Z")

</div>

Stu, I would get in touch with Andrew at Arcdroid. He has always been very helpful with any questions/problems I have had. Might save you some grief. Dale