Miller 875. What torch?

[mtw1]

@BLC79ER I have the Miller 625, I chose the shorty machine torch, it works great, I have the option with this torch to run 30a or 40a consumables, the 30a gives a slightly finer cut.

The machine torch works better than hand torch as it’s easier to manage the cable into the torch being it is vertical, VS horizontal and moves a considerable amount thru the swing, I have cut on the droid with both , and now use only the machine torch. The bonus is, it’s required to cut skeletons off of base material in order to move the material in to continue cutting, so I just unplug my machine torch and connect hand torch for quick cleanup , then switch back to carry on cutting with the Arcdroid…

That’s my experience, I hope it helps

Here is a link showing the setup I use. I did clearance the clamp in the sled to accommodate the machine torch

My table setup, water bath, tablet holder etc

Here’s what I’m using for my Arcdroid I made a table for hand torch and plasma cutting a few years back, I’ve dedicated it to the AD now, used a bunch of misc odds and ends and made a tablet holder, pivot on heim joints, adjustable vertically and tilt for glare. Cut down a 55g drum and use it as a water bath, only need an inch of water, also running a miller smoke eater, works great, no fumes in the shop. Miller Spectrum 625 provides the heat A section of pex tubing supports the cable to the …