Greetings from Calgary

[bobplewajr]

@Behemoth60 Welcome! Ahhhhh…I remember the anticipation. I attached a link to the compatible cutters.

The New Compatible Plasma Cutter List

A Low Frequency start Plasma cutter is required for the ArcDroid™ to function properly All cutters below have been tested by us or confirmed by Users. There may be more Please add your experience in the comments below. NOTE: When searching for your own Plasma cutter Pilot Arc does NOT equal low frequency start. Everlast PowerPlasma 52i/62i and 82i 256Si and 164 Si Three in one Hypertherm Powermax 30i (Air), 30XP 45,45XP, 65/65 Sync 85/85 Sync (all in the Powemax & Sync series should…

Hope it arrives soon. You’re gonna have a blast.
Good Luck