Calibrated, but having difficulties

[Andrew]

@Prdmotorsport

Sounds like you are having issues with “False Probe”

Thread here

Not probing before every cut causing the torch height to be too far to pierce

@jplath Hey Josh You are a victim of the the dreaded “False Probe”. It’s purely a mechanical thing. The ArcDroid probes by sensing slack in the Z cable. So if anything causes the torch to Hang up prematurely it will cause it to probe higher than expected. So make sure your Z slides are Clean and lightly lubricated. Make sure your torch cables are well supported and that they are not causing undue torque on the Z slides. And don’t zip tie or otherwise attach anything to the Z cable. You ca…

Video here https://www.youtube.com/shorts/dyW6NQhQyJI

Cheers
AM